Introduction:
Dystocia in sheep means that they have difficulty giving birth. Dystocia is extremely common in sheep and causes the death of many lambs and ewes. A study conducted in New Zealand showed that dystocia accounted for 50% of deaths among new-born lambs. When lambing takes more than one hour after rupture of the foetal membranes it is classed as dystocia (D. Lunau, 2011). Obesity and lack of exercise during late pregnancy increase the chances of dystocia in sheep. Noticing and interfering with dystocia early will result in a satisfactory outcome for both ewe and the lamb. Yearling mothers are much more susceptible to problems than animals that have previously given birth. It was reported that more than 60% of dystocia was diagnosed in yearlings (Z. B. Ismail, 2016).
Get Help With Your Essay
If you need assistance with writing your essay, our professional essay writing service is here to help!
Essay Writing Service
Causes of Dystocia:
There are many causes of dystocia. Dystocia in sheep can be caused by either maternal or foetal factors. The main causes include foetal postural abnormalities, incomplete dilation of the cervix and cervicovaginal prolapse. The foetal postural abnormalities include head deviation, forelimb flexion, breech presentation and dog sitting position. The main maternal cause was the failure of full cervical dilation (causes 30% of dystocia cases in sheep). Oversized foetus (large head, wide shoulders or just a large foetus in general) and narrow pelvis are huge factors related to dystocia. Common mistakes when dealing with dystocia include allowing the ewe to be in labour too long before intervening, trying to deliver a lamb that is in an abnormal position and applying too much force. If a ewe is in labour (i.e. Stage 2) for thirty-forty minutes with no progress, then intervention is advised. If they are in labour too long it can lead to a haemorrhage, shock, infection and a dead lamb. The birth canal of a sheep is very small. So it should be ensured that the lamb is positioned properly before it enters the birth canal, as it is very difficult to manipulate the position in the birth canal. Correcting the position of the lamb must be done so before trying to remove the lamb. The correct position of a lamb is the head and front legs coming first through the birth canal, right-side up. It should never be attempted to remove a lamb that is in an abnormal position. Many ewes die because of prolonged manipulation of lambs in the birth canal. It is emphasized by all veterinary professionals that extensive attempts at manual delivery of the foetus are associated with poorer outcomes in relation to the survival of both the ewe and the new-born. Excessive force can result in shock, haemorrhage, infection, fertility problems, and a prolapse of the vagina and uterus is also possible. The force used when assisting with the lambing process should be minimal. The cervix should never be forced open! It will dilate as much as it can naturally. Causing extra unnecessary pain should be avoided. Basically, simple assistance should be provided if the assistance doesn’t help make progress then a caesarean section must be performed. A delayed delivery can result in a dead lamb and an injured ewe (A.H.M. Ali, 2011). Dystocia shouldn’t cause problems in the future however if the above mistakes are made then serious problems may be encountered.
Caesarean Section:
A caesarean section is performed on 1 in 5 ewes (L. Wilson, 2007). Early intervention for performing a caesarean section results in the delivery of live lambs and much healthier ewes. The most common complication after performing a caesarean is a retained placenta, which is more likely to occur in ewes that received prolonged assistance. Vaginal or uterine tears are common when surgical intervention was delayed.
Surgery is done on the right side of the ewe. The reason behind this is that the uterus is easily accessible on the right side, it is right under the skin. If it was done on the left side, then the intestines and many other organs must be removed to get to the uterus. The ewe should be placed on some straw bedding in right lateral recumbency. The legs and head are tied to stop the ewe from moving. Sedation may or may not be administered to the ewe, to help with positioning of ewe for surgery. However, sedation is not advised if it is expected to deliver a live lamb because of possible severe cardiopulmonary and nervous depression. Most of the left side is clipped, the skin is scrubbed with some warm water and an iodine is applied, to ensure the area is as clean as possible. The line of incision is numbed with local anaesthetic (e.g. 1% lidocaine). The incision should be made vertically down the left paralumbar fossa or low flank and at 20cm in length. When making the incision, care should be taken to ensure the rumen wall isn’t cut into. This is easily done as the muscle layers are very thin. The uterus is pulled externally, to prevent the spillage of foetal fluid into the abdominal cavity, and an incision is made along the greater curvature. It should start between the hooves of the foetus, to avoid cutting the foetus. A sterile scissors should be used to cut the uterus along the leg, starting from the incision made at the hooves. The amniotic fluid pours out of the uterus and the lamb is pulled out. The lamb is then passed on to an assistant. The assistant must swing the lamb upside down to clear the fluid from its nose. The lamb should be rubbed dry with a towel and their breathing should be stimulated. The uterus is then sutured using a double layer of suture pattern with a non-synthetic absorbable suture material. The abdominal cavity is washed out with sterile saline in case some amniotic fluid dripped in. The peritoneum and muscle layers are the closed using absorbable suture material in a simple continuous pattern. The skin is closed using non-absorbable sutures in a simple uninterrupted pattern and cleaned. Post-operative antibiotics (e.g. meloxicam or Flunixine meglumine) and nonsteroidal anti-inflammatory drugs are administered once the ewe is cleaned up and these must continue for 5 to 7 days. The skin sutures are removed within 10-14 days. (A. O’Brien, 2015, Z.B. Ismail, 2016).
Find Out How UKEssays.com Can Help You!
Our academic experts are ready and waiting to assist with any writing project you may have. From simple essay plans, through to full dissertations, you can guarantee we have a service perfectly matched to your needs.
View our services
Conclusion:
It is obvious that timing is important when dealing with a case of dystocia. If a sheep is in labour too long, the outcome is usually a dead lamb and an extremely injured ewe, or possibly even a dead ewe also. Primiparous mothers are commonly diagnosed with dystocia, so extra care should be taken with these ewes when they start lambing. The survival of both the ewe and the lamb is hugely influenced by the time delay between the start of labour and the presentation for a caesarean section. Dystocia is a common problem but extra care should be taken to ensure other problems aren’t encountered when assisting the animal. Dystocia shouldn’t affect the health of the sheep in the future. The main points to remember when dealing with dystocia is: use minimal force, never try to deliver a lamb in an abnormal position and never allow a ewe to be in labour for too long (30-40 minutes in Stage 2) before intervening.
Essay Writing Service Features
Our Experience
No matter how complex your assignment is, we can find the right professional for your specific task. Contact Essay is an essay writing company that hires only the smartest minds to help you with your projects. Our expertise allows us to provide students with high-quality academic writing, editing & proofreading services.Free Features
Free revision policy
$10Free bibliography & reference
$8Free title page
$8Free formatting
$8How Our Essay Writing Service Works
First, you will need to complete an order form. It's not difficult but, in case there is anything you find not to be clear, you may always call us so that we can guide you through it. On the order form, you will need to include some basic information concerning your order: subject, topic, number of pages, etc. We also encourage our clients to upload any relevant information or sources that will help.
Complete the order formOnce we have all the information and instructions that we need, we select the most suitable writer for your assignment. While everything seems to be clear, the writer, who has complete knowledge of the subject, may need clarification from you. It is at that point that you would receive a call or email from us.
Writer’s assignmentAs soon as the writer has finished, it will be delivered both to the website and to your email address so that you will not miss it. If your deadline is close at hand, we will place a call to you to make sure that you receive the paper on time.
Completing the order and download