Safety when soldering Free Essay Example

Am going to give an account of good and bad practices when carrying out soldering in a workshop so I could get my aim. Also am going to base around environmental issues as well as equipment conditions and the hazards that could happen. There its lots of safety when soldering. The ways of good practice when carrying out soldering in workshop is that you should wait for the flux gets heated and then you use solder. Also when soldering you should take you time and being careful gives you the time to get it in a perfect place and not making mistakes.

Also your solder iron should be in a good condition because of you health and safety and making the best PCB. You have to be careful of the temperature of the solder because it could damage the PCB or even go through it. When soldering you should have space and time to make a perfect PCB and also make sure no is one is in your way and making stop from doing the work.

The ways of bad practice when carrying out soldering in workshop is that when the solder don’t heat up and you touch it to check it if it works and that could affect you the safety.

Also a bad way is when you don’t now what you’re doing with a solder iron. Also fumes which gives you headache which is caused by lead and are dangerous. The bad ways of soldering is when you don’t know what you doing and you don’t care.

Also not taking your time on the work. The most dangerous thing is when you touching the solder and getting burned when it is hot. The two materials that are used when soldering is lead and colophony. These materials are very dangerous and can be hazards. Colophony is serious health hazard to people it could cause breathing problems.

In my conclusion soldering is a very good thing to use in a workshop and gets you work done. But there is some dangers of using which are you could burn your self. Safety in electronic circuit Design and construction My aim is to describe the advantage and disadvantages of producing a circuit board by acid etching. The advantage is that is good to use for school, workshop and laboratory and there is many more place they use it because it’s very helpful and easy to use. Acid etching is a acid but the covering the acid in the glass.

Mostly people get it because it’s cheap and it last for a long time. They also use it because it’s very good for single PCB. They use it for single PCB because acid etching is safe and if they use it in a good way is very helpful to the person, but they have to have there safety equipment so it well make it safe. Also acid etching gives a smooth finish to the PCB. The acid etching also has disadvantages which are it takes long time to dry. It also has a hazard which is corrosion and it well affect to your skin if you touch it or if it goes on your tissue.

Also if you breathe it in it could affect your breathing and it could go to your nose and in to your body. Acid etching also has high toxic fumes which are harmful to your body. In my conclusion I thing it’s a good thing to use because it’s cheap but it may take time and it’s very easy way to use it and I thing it’s very safe for a person to use it, only if they have their safety equipment. Also its very good thing for clear etching and it makes it easy for the person who is using it because it makes it clear to see.

Remember! This is just a sample.

You can get a custom paper by one of our expert writers.

Get your custom essay

Helping students since 2015